– Scroll saw
– Hand Grinder
– Square logs
– Super glue 502 (or wood glue)
– 3W LED bulb, light bulb
From a large log saw cut into 6mm thick, 35mm wide
Using a grinding machine with fine sanding discs (about 240 grit smooth) grinding surfaces and edges.
We first make the base of the lamp:
Cut four bars of size: 6mm x 35mm x 150mm then use a saw or grinder angle 45 degrees two ends of the wooden bars as in the picture.
Use square glue to stick two sides to the square
We get the base
Cut four cubes of size 10 x 10 x 10 mm
Apply Super glue on four corners and one edge and smooth the whole
Merge four bars into a single 136 x 136 mm. Just reached the base of the lamp
Get into the base of the lamp and drill four holes at four corners for screwing in
Drill a hole in the center of the wood to fix the lamp
Add a plug as shown
Remove a hole at the base of the lamp just to put the plug in
Make the lamp body:
Slice 32 wooden rods with dimensions 150 x 15 x 6 mm and smooth the whole
Apply the glue on the lamp base as shown in the picture (paste the edges of the two sides)
Same paste but overlap two bars pasted and perpendicular to them
Sequence of 32 wooden rods
Grinding and We have the product
Make the top of the lamp:
We also match the same wood with the size 150 x 150 x 6mm
Stick a preprinted piece onto the wood. Use the Scroll saw and cut off the excess according to the drawing. Grind everything. Then glue to the top of the body of the lamp.
Connect the lamp bracket to the lamp socket, insert the lamp and screw it into the lamp base
We finally finished a beautiful wooden lamp. We hope with this kind of desk lamp will contribute to your room more beautiful. Thank you for visiting our website.